hitar_potar написа:Интринсик Еър по принцип е компресия без платформа. Следователно и моя шок няма такава - аз и не съм усетил платформа. Вилката ми също е с Интринсик Еър (Маниту Травис Сингъл 2008) и комбинацията е изключителна.
Честно не знам кой е твоят шок и не мога да коментирам какво пише на него или какво има вътре. Но ето малко инфо от маниту:
SPV DAMPING: EVOLVER SPV, SWINGER COIL SPV,
and S-TYPE SPV REAR SHOCKS
SPV damping creates an efficient platform to eliminate excessive movement
(bobbing) from low resonance forces such as pedaling. To adjust platform, first set
the pressure in the SPV chamber to roughly 75 psi (5 bar) BEFORE MAKING ANY
SAG ADJUSTMENTS. Only after proper sag has been set should you then fine-tune
your SPV pressure adjustment. Changing SPV pressure alters your platform
threshold. Higher SPV pressures will provide a firmer platform for firmer pedaling,
firmer ride control and a higher blow-off threshold. Likewise, decreasing pressure
in the SPV chamber decreases platform.
INTRINSIC DAMPING: REVOX, SWINGER and EVOLVER
Designed to provide a high degree of bump sensitivity and wide range of
adjustment, speed sensitive Intrinsic damping is a must-have for long travel
suspension bikes. All Intrinsic shocks feature externally adjustable bottoming with
the No Tools volume adjustment. Higher-end Intrinsic shocks feature high- and
low-speed compression damping adjustments (located inside the piggyback
reservoir) as well. SWINGER COIL X6, REVOX and EVOLVER ISX-6 have the added
feature external adjustment of the high- and low-speed compression damping
circuit. The red knob controls low-speed compression and the black knob controls
high-speed compression.
NO TOOLS VOLUME ADJUSTMENT: REVOX and ISX SHOCKS
Volume adjust allows the rider to change the compression ratio of the air in the
piggyback reservoir. Higher settings create more ramp-up effect as the shock
compresses. Air volume settings allow the user to adjust the compression ratio.
The No Tools volume adjuster is located on the end of the piggyback reservoir. The
volume adjuster controls the rear shock’s bottoming resistance by varying the rise
in compression ratio during the last 50% of the rear shock stroke. The No Tools
volume adjuster has four numbered settings with different volumes. The #1
position has the largest volume, so this is the least progressive of all of the
settings. The #4 position corresponds to the most progressive feel. When making
air pressure adjustments on the reservoir, the volume adjuster should be set to the
#1 position.
В крайна сметка аз все още съм объркан кой шок с какво е, когато ги пише и двете неща на него
